$CMDLINE PARAMS

[GoogleDude]

Somewhere a while back I found this peace of code to make it so my script could be run using a command line switch. See below.

If $CMDLINE[0] And $CMDLINE[1] = '/switch' Then
    ;Do something
EndIf

What I am now wanting to do but having a hard time understanding is how to I make it so part of the passed switch is dynamic in that is is read from the command line at the time the script it run and passed along as a $var to be used in my script. An non-working example of what I was looking for it below.
Where MyUsername and MyPassword are provided at runtime then MyUsername and MyPassword become $MyUsername and $MyPassword to be used inside script.

If $CMDLINE[0] And $CMDLINE[1] = '/U MyUsername /P MyPassword' Then
    ;Do something
EndIf

Thanks for any help.

[guinness]

Use _ArrayDisplay() on $CmdLine and you will see those switches are parsed as single entities.

[Jos]

This is how I do commandline lexing in AutoIt3Wrapper. Left 2 parameters that expect an value and 1 that is just a single parameter.

#Region Commandline lexing
; retrieve commandline parameters
;-------------------------------------------------------------------------------------------
For $x = 1 To $CMDLINE[0]
    Select
        Case $CMDLINE[$x] = "/in"
            $x = $x + 1
            $ScriptFile_In = $CMDLINE[$x]
        Case $CMDLINE[$x] = "/out"
            $x = $x + 1
            $ScriptFile_Out = $CMDLINE[$x]
        Case $CMDLINE[$x] = "/Noparam"
            $INP_Noparam = "y"
    EndSelect
Next
#EndRegion Commandline lexing

Jos